Konica Minolta magicolor 2490MF Service Manual page 317

18. FAX error
Code
00BC Modem not ready within 10 second after entering primary channel in V.34.
00BD Can not detect correct V.21 or JM signal after detected FSK frequency.
00BE Remote side no document to be polled after V8 handshaking.
00BF Capability not match after V8 handshaking.
00C0 Remote side disconnect before entering primary channel in V.34.
At phase-D, transmitting unit sends out EOP 3 times consecutively, but receives no answer
00C1
from receiving unit.
00C2 Remote side disconnect after sending out V.8 CM signal.
00C4 After sending MPS signal, the received signal is not one of MCF, RTN, PIP, PIN, RTP, DCN.
00C5 Received DCN signal after sending MPS signal.
00C9 At phase-D, sending MPS 3 times consecutively, but no answer from receiving unit.
After sending EOP signal, the received signal is not one of MCF, RTN, PIP, PIN, PRI-EOP,
00CA
DCN.
00CB After sending EOP signal, the received signal is DCN signal.
00CC After sending EOM signal, the received signal is not one of MCF, RTN, PIP, PIN, RTP, DCN.
00CD At phase-D, transmitting unit sends out EOM 3 times consecutively, but receives no answer.
00CE At phase-D, transmitting unit sends out EOM, but receives DCN.
00CF Received incorrect signal after sending DTC signal for V.34 polling.
00D0 Received ERR signal after sending EOR_NULL.
00D1 Received incorrect response after sending PPS_EOP signal in V.34.
00D2 Receive DCN after send command PPS_EOP signal.
00D3 Received DCN after sending PPS_NULL signal.
00D4 Received DCN after sending PPS_EOM signal.
00D8 Did not detect correct phase 3 signal for polling within 25 seconds.
00D9 Did not detect correct phase 3 signal after detecting silence after phase 2.
00DA Did not detect phase 4 signal within 30 seconds or remote side hang up over 6 seconds.
00DB Did not receive any T.30 signal within 15 seconds in phase 4.
00DC Received T.30 signal in phase 4 other than DCS, DIS or DTC.
00DE Remote side no SUB capability in V.34.
At phase-D, transmitting unit sends out PPS_NULL 3 times consecutively but receives no
00E0
answer.
00E1 Received incorrect response after sending PPS_NULL.
00E2 Did not receive any response in RR response procedure after sending PPS_NULL.
00E4 At phase-D, transmitting unit sends out PPS_MPS 3 times consecutively but no answer.
00E5 Received incorrect response after sending PPS_MPS.
00E6 Did not receive any response in RR response procedure after sending PPS_MPS.
00E7 Received DCN after sending PPS_MPS.
00E8 At phase-D, transmitting unit sends out PPS_EOP 3 times consecutively but no answer.
00E9 Receive PIN signal after sent last page three times.
00EA Did not receive any response in RR response procedure after sending PPS_EOP.
00EB At phase-D, transmitting unit sends out PPS_EOM 3 times consecutively but no answer.
00EC Received incorrect response after sending PPS_EOM.
00ED Did not receive any response in RR response procedure after sent out PPS_EOM.
278
Field Service Ver. 1.0 Jul. 2006
Possible Causes of Error.