Leg Supports; Armrests - Vermeiren Eclips+ Instruction Manual

LEG SUPPORTS

7
5
8
4
6
Adjusting the footplates
The footplates (6) can be set at different heights. Loosen the screw on the footplate. Now move the
boards backwards or forwards by about 3 cm. It should be secured again with the fixing screws.
Depending on the steering wheel combination and the adjustment of the steering wheel adapter, the
footplate cannot be pushed backwards, since it would obstruct the steering wheel.
Distance below the thigh
To adjust the length of the leg supports, remove screw (7) which holds the leg support, pull the inner
tube (8) to the desired position, and secure again by means of screw (7). Before use, make sure that
all screws have been tightened properly.
Kindly consult your specialist dealer about the correct adjustment of your leg supports. He will gladly
aid you and advise you about other available leg support systems.
Before use, make sure that the leg supports are securely locked in place.
L
Never grasp the wheelchair by the leg supports when picking it up for transportation, but only
by solid frame parts (see also the chapter "For your safety").
L
Make sure that the footplates are at least 2.36 in. above the ground to avoid contact with the
ground when driving; such contacts may cause damage and endanger the operational security
of the wheelchair. In addition, the user could also be injured.

ARMRESTS

In the standard model the armrests can be folded down to the rear or be removed. The arresting
device (2) is mounted on the frame tube (1) to secure the armrests.
2
Removing the armrest
Press the operating lever (1) of the armrest locking device (2). Pull the armrest up and out, or fold it
away to the rear.
To mount the leg supports, place them sideways with
the bolts (1) in the sockets of the frame tube (2). Now
turn the leg supports slowly inwards until the locking
1
block (3) slides over the suspension block (4). The
3
release lever (5) engages automatically when the end
position is reached. If the release lever (5) does not
engage, push it gently in the direction of the frame
2
tube.
To unbolt the leg supports, press the release lever (5)
gently downwards and turn the leg supports outwards
or inwards.
L
1
10
Before use, make sure that the leg supports
are securely locked in place.
4
Eclips+/Eclips+30°
11/2008
3
E