Mechanical Adjustment Of The Seat; Leg Supports - Vermeiren Squod Instruction Manual

MECHANICAL ADJUSTMENT OF THE SEAT

It is possible to change your sitting position by setting the cushioned seat to a different angle.
1
To change the angle of the seat (max. 9°), go through the following sequence:
A. Lift the seat (1) completely from the seat frame (3).
B. Reposition the fixing screws of the front seat suspension (2) and securely tighten again (this
adjustment can only be done with a suitable slotted screwdriver).
C. Put the seat back on the seat frame in such a way that the seat suspension is located on the frame
between the banking pins. By gently pressing on the seat, the seat suspension will lock onto the
seat frame.
L
Let an expert perform these activities.
L
See to it that the seat suspension is located between the banking pins on all sides.

LEG SUPPORTS

7
5
8
6
4
Adjusting the footplates
The footplates (6) can be set at different heights. Loosen the screw on the footplate. Now move the
boards backwards or forwards by about 3 cm. It should be secured again with the fixing screws.
Depending on the steering wheel combination and the adjustment of the steering wheel adapter, the
footplate cannot be pushed backwards, since it would obstruct the steering wheel.
Distance below the thigh
To adjust the length of the leg supports, remove screw (7) which holds the leg support, pull the inner
tube (8) to the desired position, and secure again by means of screw (7). Before use, make sure that
all screws have been tightened properly.
Kindly consult your specialist dealer about the correct adjustment of your leg supports. He would
gladly aid you and advise you about other available leg support systems.
Before use, make sure that the leg supports are securely locked in place.
2 1
3
To mount the leg supports, place them sideways with
the bolts (1) in the sockets of the frame tube (2). Now
turn the leg supports slowly inwards until the locking
block (3) slides over the suspension block (4). The
release lever (5) engages automatically when the end
1
position is reached.
3
To unbolt the leg supports, press the release lever (5)
gently downwards and turn the leg supports outwards
or inwards.
2
L
Before use, make sure that the leg supports
are securely locked in place.
SQUOD Instruction Manual
Last updated: Jul. 2005
2
3
9