First of all we want to thank you for putting your trust in us by selecting one of our wheelchairs. The Vermeiren wheelchairs are the result of many years of research and experience. During the development, special attention was given to the ease of use and the serviceability of the wheelchair.
Eclips X4 kids 90° 2014-08 Product description Intended Use The wheelchair is intended for people with walking difficulties or no walking abilities. The wheelchair is designed to transport 1 person. The wheelchair is suited for indoor and outdoor use. The user can propel the wheelchair by himself or have the wheelchair pushed by an attendant.
2 x 275 N Storage and use temperature +5 °C + 41°C Storage and use humidity We reserve the right to introduce technical changes. Measurement tolerance ± 15 mm / 1,5 kg / ° Table 1: Technical specifications Eclips X4 kids 90° Page 4...
13 = Tip cap 14 = Footrests 15 = Footplate Accessories The following accessories are available for the Eclips X4 kids 90°: Anterior pelvic belt (B20) for mounting on the tubes of the back Anti-tipping device (B78) for mounting on the lower frame ...
Eclips X4 kids 90° 2014-08 Explanation of symbols Maximum mass Indoor and outdoor use Maximum Safe Slope CE conformity Type designation Not crash tested Safety rules To prevent injury and/or damage to your wheelchair, make sure that no objects and/or body parts are caught in the spokes of the driving wheels.
Eclips X4 kids 90° 2014-08 This chapter describes the everyday use. These instructions are for the user and the specialist dealer. The wheelchair is delivered fully assembled by your specialist dealer. The instructions intended for the specialist dealer on how to set up the wheelchair are given in § 3.
Eclips X4 kids 90° 2014-08 Operating the brakes WARNING: The brakes are not used to slow down the wheelchair during movements – Use the brake only to prevent the wheelchair from unintended movements. WARNING: Good operation of the brakes is influenced by wear and contamination of the tires (water, oil, mud, …) –...
Eclips X4 kids 90° 2014-08 Riding the wheelchair WARNING: Risk of clamping – Prevent your fingers from being caught by the wheels spokes. WARNING: Risk of clamping – Be careful passing through restricted passages (e.g. doors). WARNING: Risk of burns – Be careful when driving in hot or cold environments (sunshine, extreme cold, saunas, etc.) for a sufficient amount of time and when...
Page 12
Eclips X4 kids 90° 2014-08 An experienced user can negotiate higher curbs by himself. This is best done backwards. Turn the wheelchair to have the rear wheels facing the curb. Lean forward to move your centre of gravity forward. Move the wheelchair close to the curbs.
Risk of injury – Tighten the parking brakes before adjusting the backrest inclination. With the model Eclips X4 kids 90° it is possible to set the backrest backwards with a maximum inclination of 90°. Be sure that the patient sits in the chair when the attendant shall perform the backrest adjusting and that the wheelchair does not tip over.
This wheelchair can be adjusted to individual requirements as explained below. To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility. A list of Vermeiren facilities can be found on the last page.
Risk of tipping over - When the driving wheels are adjusted, the position of the wheels are altered. The Vermeiren Eclips X4 kids 90° is adjustable in different seat heights and different seat angles by changing the wheels position. At each height there is a different setting of the front and rear wheels.
Page 16
Eclips X4 kids 90° 2014-08 Adjustment of the slope nuts Ⓒ from the steering wheels. WARNING: Risk of injury - Make sure that the eccentric screw settings are identical on both front-wheel adapters and, before using the wheelchair. This figure illustrates the principle. The position of the screw thread is indicated by a number.
Eclips X4 kids 90° 2014-08 Some of the wheelchairs Eclips X4 kids Aktief are made with an adjustable axle adjuster. With these adjuster you can also change the seat height. 1. Remove the screws and . 2. Push/Pull the adjustable axle adjuster ...
Eclips X4 kids 90° 2014-08 6. Remove the adjustable axle adapter, if available on your wheelchair. 7. Adjust the seat depth to the desired position by moving the backframe and/or seat frame steps from 20 mm. 8. Tighten all the screws properly by hand.
Eclips X4 kids 90° 2014-08 Adjusting of the footrests 3.8.1 Length of the footrests CAUTION: Risk of damage – Avoid that the footrests make any contact with the ground. Keep a minimum distance from 60 mm above the ground. Adjust the length of the footrests as follow (2 positions possible: steps 35 mm → holes outside tube, 4 positions possible: steps 25 mm →...
Risk of tipping over - Make sure that the tubes of the handgrips are positioned identically on both sides. With the model Eclips X4 kids 90° you can adjust the height of the handgrips in back tube . 1. Loosen the star knob .
3. Retighten the screws and . 4. Adjust the brakes. Please note that your wheelchair might become tipping over. To prevent this, you can also mount an anti-tipping device. Maintenance For the maintenance manual of the manual wheelchairs refer to the Vermeiren website: www.vermeiren.be. Page 19...
Page 22
Dealer´s stamp: Dealer´s stamp: Date: Date: Dealer´s stamp: Dealer´s stamp: Date: Date: Dealer´s stamp: Dealer´s stamp: Date: Date: For service checklists an additional technical information, please see our specialist dealers nearest to you. More information on our website at: www.vermeiren.com.
Page 24
Fax: +41(0)31 818 40 98 website: www.reatime.it website: www.vermeiren.ch e-mail: info@reatime.it e-mail: info@vermeiren.ch Poland Spain / Portugal Vermeiren Polska Sp. z o.o Vermeiren Iberica, S.L. Carratera de Cartellà, Km 0,5 Łączna PL-55-100 Trzebnica Sant Gregori Parc Industrial Edifici A Tel: +48(0)71 387 42 00...