Inspection - Vermeiren Eclips+ Instruction Manual

E

INSPECTION

In principle we recommend one inspection every twelve months, and a minimum of one before usage
is resumed. All of the following checks must be performed and documented by authorized persons:
• Check the frame parts and the hinged tubes for plastic deformation, tears and impaired
functioning
• Visually check for damage to the paintwork (danger of corrosion)
• Check the operation of the wheels (free running, level rolling, axle play, tyres, profile, condition
of the rims, air pressure (in the case of pneumatic tyres), floating axles, etc.)
Check the solidity and seating of all screws
•
• Verify the amount of grease on the metal joints of movable parts
• The condition and security of the guides and axles of the steering wheels (castor nuts)
Visually check all plastic parts for tears and brittle spots
•
• Check the functioning of the armrests and leg supports (locking, load, deformation, wear and
tear caused by loads)
• Check functioning of the gas pressure spring (synchronized, deformation, oiled) (only with
Eclips+30°)
Check the operation of other detachable parts (e.g. anti-tipping device, personal safety belt,
•
headrest, fitting of back/seat, container for walking stick, etc.)
• Completeness of the delivery condition, instruction manual available ?
The service must only be signed off in the service plan if a minimum of all the above-mentioned
aspects have been checked. If your specialist dealer is incapable of performing the required services,
please contact the manufacturer. We shall gladly refer you to authorized specialist dealers in your
area.
The manufacturer is not liable for damage caused by the lack of or improper service.
21
Eclips+/Eclips+30°
11/2008