Leg Supports - Vermeiren Eclips X4 Instruction Manual

LEG SUPPORTS

7
8
6
Before use, make sure that the leg supports are securely locked in place.
Adjusting the footplates
The footplates (6) can be set at different heights. Loosen the screw on the footplate. Now move the
boards backwards or forwards by about 3 cm. It should be secured again with the fixing screws.
Depending on the steering wheel combination and the adjustment of the steering wheel adapter, the
footplate cannot be pushed backwards since it would obstruct the steering wheel.
Distance below the thigh
To adjust the length of the leg supports, remove screw (7), which holds the leg support, pull the inner
tube (8) to the desired position, and secure again by means of screw (7). Before use, make sure that
all screws are tightened properly.
Kindly consult your specialist dealer about the correct adjustment of your leg supports. He would
gladly aid you and advise you about other available leg support systems.
Before use, make sure that the leg supports are securely locked in place.
Never grasp the wheelchair by the leg supports when picking it up for transportation, but only
by solid frame parts (see also the chapter "For your safety".)
Make sure that the footplates are at least 6 cm above the ground to avoid contact with the
ground when driving; such contacts may cause damage and endanger the operational security
of the wheelchair. Furthermore, the patient might also be injured.
To mount the leg supports, place them sideways with
the bolts (1) in the sockets of the frame tube (2). Now
turn the leg supports slowly inwards until the locking
block (3) slides over the suspension block (4). The
release lever (5) engages automatically when the end
position is reached. If the release lever (5) does not
engage, push it gently in the direction of the frame
tube.
To unbolt the leg supports, press the release lever (5)
gently downwards and turn the leg supports outwards
or inwards.
Instruction Manual Eclips X4
Last updated: May 2003
10