Cleanup - MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions

MK-212 SAW

CLEANUP

NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of wastewater in accordance with applicable Federal, State and Local laws.
(A)
Clean the Water Pump suction
of all debris
CAUTION
(D)
Ensure the ON/OFF Switch is
in the OFF position
(G)
Clean the MK-212 with soap
and clean water
Place the Water Pump in an
external container
Ensure the saw is disconnected before completing the remainder of the cleanup process.
Unplug the GFCI from the
Drain the Water Basin and
dispose of the water in
accordance with all State,
Local and Federal laws
(B)
(E)
Power source
(H)
25
CLEANUP
(C)
Run the saw until clear water
is seen at the blade cooling
ports (Approx. 1 minute)
(F)
Unplug MK-212 from the
GFCI
(I)
Clean the Water Basin