Unpacking; Contents; Transport - MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions

Table of Contents

Advertisement

MK-212 SAW

UNPACKING

Your MK-212 has been shipped from the factory thoroughly inspected. Only minimal assembly is required.
CAUTION

CONTENTS

I
n your container, you will find one (1) MK-212 Saw, (4) MK-212 support legs, (1) 10-inch wet cutting continu-
ous rim diamond blade, (1) blade wrench, (1) 90° cutting guide alignment plate, (1) 90° cutting guide, 90° cut-
ting guide hareware, (1) 2-piece protractor (1) drain plug, (1) electric water pump, (1) pump discharge fitting,
(1) cooling transfer tube, (1) flow regulating clamp, (1) 5/16" allen wrench, (1) 5mm allen wrench, (1) owners
manual, (1) pump manual and (1) warranty card.
MK-212 Saw
90° Cutting Guide
Hardware
Flow Regulation
Clamp

TRANSPORT

1. The MK-212 weighs approximately two hundred and twenty-six (226) pounds and for that reason should not be
transported without a minimum of two persons present.
2. Never transport the MK-212 with water in the Water Pan.
Lift Point
Use proper lifting techniques when lifting the MK-212.
MK-212
Diamond Blade
Support Legs
2-Piece
Drain
Protractor
Plug
5/16" Allen
5mm Allen
Wrench
Wrench
Blade Wrench
90° Cutting Guide
Alignment Plate
Electric Water
Pump Discharge
Pump
www.mkdiamond.com
www.mkdiamond.com
MK-212 SERIES
MK-212 SERIES
OWNERS MANUAL &
OWNERS MANUAL &
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Revision 301
04.2009
Revision 301
04.2009
Manual Part No. 159862
Manual Part No. 159862
Caution: Read all safety and operating instructions before
Caution: Read all safety and operating instructions before
using this equipment. This owners manual MUST accompany
using this equipment. This owners manual MUST accompany
the equipment at all times.
the equipment at all times.
MK Diamond Products, Inc.
MK Diamond Products, Inc.
Owner's
Manual
Cutting Head
Locked Down
Remove Movable
Cutting Table
14
UNPACKING
90° Cutting Guide
Cooling Transfer
Fitting
Tube
Pump
Warranty
Card
Manual
NOTE: The Cutting
Head end will be heavier
than the opposite end.

Advertisement

Table of Contents
loading

Table of Contents