MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions page 34

MK-212 SAW
CUTTING HEAD DOES NOT MOVE CORRECTLY
(A)
Check that Guide Rail and
Cutting Head is clean and
clean if dirty
BLADE STOPS TURNING
(A)
Check the ON/OFF Switch is
in the ON position
(D)
Verify the circuit breaker is at
least 20 amps – if not, move
to 20 amp circuit
(B)
Lubricate the Guide Rail and
Cutting Head
(B)
Verify all plugs are fully
connected
(E)
Verify circuit breaker not
tripped; if it is tripped, reset it
once only
34
MAINTENANCE
(C)
Check the Cutting Head
alignment.
(C)
Check to see if the Ground
Fault Circuit Interrupter
(GFCI) tripped
(F)
Check power source voltage
is 115v – if not 115v, move to
another circuit.