External Water Source - MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions

MK-212 SAW
WATER PUMP SETUP FOR OPERATION
The Water Pump can be setup for operation in two ways, External Water Source or Re-circulation.
NOTE: If using a dry blade for operation, DO NOT connect the water pump.

EXTERNAL WATER SOURCE

This is the preferred method of cooling.
(A)
Press the free end of the
Cooling Transfer Tube onto
the Blade Guard Cooling Port
(D)
Place the Water Pump in an
external container
(B)
Connect the Water Pump to
the MK-212
(E)
Fill the external container
until water completely covers
the Water Pump suction
20
SETUP
(C)
Remove the Drain Plug
(F)
Place an external catch basin
below the Water Basin drain
hole