MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions page 28

MK-212 SAW MAINTENANCE
FLOW ADJUSTMENT
NOTE: If flow to the diamond blade requires adjustment, perform the following actions.
(A) (B)
Increase cooling flow by Reduce cooling flow by
releasing the Flow Adjusting pressing down on the Flow
Clamp Adjusting Clamp
DIAMOND BLADE CHANGE-OUT
NOTE: When installing the Retaining Nut do not "cross-thread" and DO NOT over tighten the screw.
(A) (B) (C)
Loosen the Cutting Head Move the Cutting Head to Tighten the Cutting Head
Transverse Knob one end of the saw Transverse Knob
(D) (E) (F)
Loosen the Blade Guard Pivot Loosen the Blade Guard Open the Blade Guard
Point Retaining Wingnut Retaining Knob
28