Safety Label Locations; Product Specifications - MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions

MK-212 SAW

SAFETY LABEL LOCATIONS

Safety labels are located according to the table below and the exploded views at the end of this manual. The
labels contain important safety information. Please read the information contained on each safety label. These
labels are considered a permanent part of your saw. If a label comes off or becomes hard to read, contact MK
Diamond or your dealer for a replacement.
CAUTION
!
Receptacle is for
water pump only.
125V, .6 amps max.
Label A
CAUTION
!
This saw is to be used
with a Ground Fault
Circuit Interrupter.
Label B
FOR INFORMATION ON
SERVICE OR
WARRANTY
PLEASE CALL
1-800-474-5594
Label C
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
115v 230v
25'
50'
75'
Tile Master Label Sheet Part#166012
Decal/Label
A
B
C
D
E
F
TILE SAW SPECIFIC WARNINGS
WARNING
Wear eye protection.
Use splash guard for every operation for which it can be used.
Disconnect saw before servicing, when changing cutting blades, and cleaning.
Replace damaged cutting blade before operating.
Tile Saws
WARNING
!
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
WARNING
!
For Your Own Safety Read Instruction Manual
Before Operating Saw.
Wear Eye Protection.
Disconnect Saw Before Servicing, when Changing
Cutting Wheels and Cleaning.
Use Tool Only with Smooth Edge Cutting Wheels
Free of Openings and Grooves.
Replace Damaged Cutting Wheel Before Operating.
Do Not Fill Water Bath Above Water Fill Line.
See Manual for Pump Replacement.
Label E
NOTICE
!
100' Max. Cord Length No. 12 Wire
150' Max. Cord Length No. 10 Wire
250' Max. Cord Length No. 8 Wire
Label F
Location
Switch Box
Cutting Head
Cutting Head Arm
Motor - Back
Motor - Back
Motor - Back

PRODUCT SPECIFICATIONS

Label B
Label D
Label E
(Not Shown)
Description
Caution - Receptacle is for Water Pump Only
Caution - Use with GFCI only
Service/ Warranty
Warning - Silica Warning
Warning - Read Owners Manual
Notice - Voltage/extension cords
12
Label F
Label C
Label D
Label A