MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions page 29

MK-212 SAW
DIAMOND BLADE CHANGE-OUT
NOTE: When installing the Retaining Nut do not "cross-thread" and DO NOT over tighten the screw.
(G)
Loosen and remove the Blade
Retaining Nut
NOTE: The Diamond Blade will have to be installed onto the MK-212 with the Directional Arrow toward
the motor side of the Cutting Head for the blade to be seated correctly.
(J)
Install the new Diamond Blade
onto the Blade Shaft
(M)
Install the Blade Retaining Nut
(H)
Remove the Outer Flange
(K)
Verify the Directional Arrow
of the Blade matches the
Directional Arrow of the Blade
Guard
(N)
Verify the Blade Retaining Nut
is seated in the Outer Flange
29
MAINTENANCE
(I)
Remove the old Diamond
Blade
(L)
Install the Outer Flange
(O)
Tighten the Blade Retaining
Nut