MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions page 30

MK-212 SAW
(P)
Close the Blade Guard
TABLE REMOVAL
NOTE: The Rubber topped cutting table may be removed to replace the rubberized surface or to clean the
Water Basin.
(A)
Remove the Adjustable Cutting
Guide
(D)
Remove all Retaining Screws
using the Hex Wrench provided
with the MK-212
(Q)
Tighten the Blade Guard
Retaining Knob
(B)
Remove the 90° Cutting Guide
Alignment Plate
(E)
Remove table Cutting
Surface pieces
30
MAINTENANCE
(R)
Tighten the Blade Guard
Pivot Point Retaining
Wingnut
(C)
Locate the six table Retaining
Screws on both sides of the
cutting surface
(F)
Clean the Water Basin