Lock Out Method - MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions

MK-212 SAW
WARNING
Use only extensions cords that are intended for outdoor use. These extension cords are identified by a
marking "Acceptable for use with outdoor appliances; store indoors while not in use." Use only extension
cords having an electrical rating not less than the rating of the product. Do not use damaged extension cords.
Examine extension cords before using and replace if damaged. Do not abuse extension cords and do not yank
on any cord to disconnect. Keep cords away from heat and sharp edges. Always disconnect the extension
cord from the receptacle before disconnection the product from the extension cord.
WARNING
To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug with
wet hands.
WARNING
Use of undersized extension cords result in low voltage to the motor that can result in motor burnout and
premature failure. Barranca Diamond warns that equipment returned to us showing signs of being run in a
low voltage condition, through the use of undersized extension cords will be repaired or replaced totally at
the customers expense. There will be no warranty claim.
To choose the proper extension cord,
• Locate the length of extension cord needed in table provided.
• Once the proper length is found, move down the column to obtain the correct AWG size required for
that length of extension cord.

LOCK OUT METHOD

In order to help prevent accidental starting and to help
make your work area "kidproof," this machine is provided
with a means to deactivate the functioning of the motor
switch. The switch is equipped with a lockout tab that can
be used with a lock to prevent movement of the switch.
With the switch unable to move the motor cannot be
turned on. Removing the lock reactivates the switch.
EXTENSION CORD MINIMUM GAGE FOR LENGTH
VOLTS TOTAL LENGTH OF CORD IN FEET
25 ft. 50 ft.
120v AWG AWG
18 16
100 ft.
AWG
16
Table 1
Fig. 3 Lock Out
11
SAFETY
150 ft.
AWG
14