MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions page 16

MK-212 SAW
(J)
Tighten the Cutting Head
Transverse Knob
DIAMOND BLADE INSTALLATION
NOTE: When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the screw.
(A)
Loosen the Cutting Head
Transverse Knob
(D)
Loosen the Blade Guard Pivot
Point Retaining Wingnut
(K)
Install the remaining to Legs
on the opposite side of the
saw using Steps D through G
(B)
Move the Cutting Head to
one end of the saw
(E)
Loosen the Blade Guard
Retaining Knob
16
ASSEMBLY
(C)
Tighten the Cutting Head
Transverse Knob
(F)
Open the Blade Guard