Angle Cuts - MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions

MK-212 SAW
ANGLE CUTTING
NOTE: To cut at an angle, the MK-212 has been designed with a pivoting cutting head.
CAUTION
(A)
Loosen the two Beam Post
Cutting Head Pivot Knobs
located on each end of the saw
(D)
Place the tile against the Stop
and Cutting Guide
(G)
Verify proper cooling flow on
both sides of the blade
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
Pivot the Cutting Head and
retighten the two Pivot Knobs
Verify the tile is seated against
the Stop and Cutting Guide
Perform the cut
(B)
(E)
(H)
23
OPERATION
(C)
Position the Adjustable Cutting
Guide to desired cut length
(F)
Turn the motor ON
(I)
Turn the motor OFF when
work is complete