Off-Angle Cuts - MK Diamond Products MK-212 SERIES Owner's Manual & Operating Instructions

MK-212 SAW
OFF-ANGLE CUTTING
NOTE: To cut angles other than 90º, a Protractor (MK Diamond Part No. -159572) should be used.
CAUTION
(A)
Remove the Adjustable
Cutting Guide
(D)
Position the tile against the
Protractor and the Stop
(G)
Verify proper cooling flow on
both sides of the blade
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
Place the Protractor on the side
of the cutting table. Adjust the
Protractor to fit the tile being cut and
tighten the Retaining Knobs to lock
the Protractor
Verify the tile is seated against
the Stop and Protractor
Perform the cut
(B)
(E)
(H)
24
OPERATION
(C)
Set the desired Cutting Angle
and tighten the Retaining Knob
(F)
Turn the motor ON
(I)
Turn the motor OFF when
work is complete