Adjustable Cutting Guide Installation; Splash Guard Installation; Water Pump Preparation - MK Diamond Products MK-100 JCS Owner's Manual & Operating Instructions

UNPACKING, TRANSPORT, JCS STAND and ASSEMBLY

3. Adjustable Cutting Guide Installation:

NOTE: The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
Turn counter- Adjustable
clockwise to loosen Cutting Guide
Ruler/Stop
(A)
Loosen Adjustable Cutting
Guide retaining thumbscrew
and place it over the Movable
Cutting Table Ruler/Stop

4. Splash Guard Installation:

Splash
Guard
Thumbscrew
(A)
Install the retaining thumbscrew
through the washer and Splash
Guard then align to the hole found
on back of the Blade Guard

5. Water Pump Preparation:

Turn clockwise
to tighten
Discharge
(A)
Install Water Pump
Discharge Fitting
MK-100 JCS Tile Saw
Turn clockwise
to tighten
Place the Adjustable Cutting
Guide onto the Movable Cutting
Table Ruler/Stop and tighten
the retaining thumbscrew
Retaining Turn clockwise
Hole To tighten
Install the Splash Guard
onto the Blade Guard
Cooling
Transfer
Tube
Fitting
Press on
Press one end of the Cooling
Transfer Tube onto the Water
Pump Discharge Fitting
Adjustable
Cutting Guide
Ruler/Stop
(B)
(B)
(B)
Revision 06/05, Effective Date June 27, 2005
Flow Adjusting
Clamp
Press on
(C)
Slide Cooling Flow Adjusting
Clamp onto the Cooling
Transfer Tube
: