MK-2000 GAS SAW
WATER PUMP SETUP
The Water Pump can be setup in three ways, External Water Source, Re-circulation or Un-coupled for
dry blade operation.
To extend the life of the Diamond Blade and Water Pump, MK Diamond recommends a
NOTE:
clean cooling water source when using a Wet Diamond Blade.
EXTERNAL WATER SOURCE
this is the preferred method of cooling when using a "wet" diamond blade.
(A)
Remove the Drain Plug and
place a catch basin below the
drain hole.
RE-CIRCULATION
NOTE:
1. Water Pump could interfere with masonry being cut.
2. Water should be periodically replaced when using this method.
(A)
Install the Drain Plug and fill
Water Basin.
(B)
Remove Water Pump from
clamp.
21
SETUP
(C)
Place the Water Pump Assem-
bly into a filled Water Container.