Water Pump Preparation; Setup - MK Diamond Products MK-170 Owner's Manual

MK-170 Tile Saw

water Pump Preparation

waRNiNG
1. To prevent the possibility of electrical shock, the MK-170 MUST be
2. To prevent the possibility of electrical shock, use only MK Diamond qualified
(A)
Install Water Pump Discharge
Fitting
(D)
Fill the Water Pan with clean
water (this should be done peri-
odically during cutting).
(G)
Connect the Water Pump pow-
er cord to the connection found
on the back of the motor.
de-energized when preparing the Water Pump for operation.
replacement parts.
Remove the Cutting Table from
Place the Water Pump in the
Water Pan-ensure the pump
suction is covered.
(B)
the Water Pan
(E)
19
(C)
Press the end of the Cooling
Transfer Tube onto the water
Pump Discharge Fitting
(F)
Install the Cutting Table; ensure
the pump power cord is sealed
in the slot behind the Post.

SeTUP