Table of Contents
Advertisement
MK-4000 SERIES
ENGAGING THE DRIVE UNIT
This saw is driven by a hydrostatic transmission. To engage the transmission, PULL the Neutral Engagement
Handle up and turn to either direction to lock.
NOTICE
DO NOT engage the unit unless FNR Handle (Figure 18) is on NEUTRAL.
Neutal
Engagement
Handle
To disengage the transmission, twist the Neutral Engagement Handle to unlock, and PUSH down.
WATER HOOK UP
Prior to starting the engine, you should hook up the water hose to the Water Inlet (Figure 19) and visually
inspect it to make sure that water is flowing to the blade. Hook up the hose to the unit and turn on the water
source. Open the water valve.
NOTICE
Water flow volume can be metered by opening the water valve partially.
Next, lift the front of the blade guard and visually inspect the make sure water is flowing out of each of the
tubes. If any of the holes is blocked, flush impurities from the tube.
Water
Valve
Engage transmission
Water Hook Up
23
OPERATION
FNR Handle
Water Inlet
Advertisement
Table of Contents
