Correctly set ready position
Fig. 155 Ready position
Read and observe
and
Correctly adjusted standby position
The locking balls
can be pushed fully into the tow bar.
A
The red marking
on the hand wheel is located in the green box on the
B
tow bar.
The key
is in the unlocked position and cannot be removed.
C
There is a clear gap of approx. 5 mm
tow bar.
The ball bar is thus set ready for installation.
CAUTION
When in the ready position, the key cannot be removed from the handwheel
lock.
on page 141 first.
» Fig. 155
between the hand wheel and the
D
Installing the ball rod
Fig. 156 Removing the cap on the rear bumper/inserting the tow bar
Fig. 157 Locking the lock and removing the key/replacing the lock cap
Read and observe
and
›
Grip the cap on the rear bumper
direction of the arrow
and remove in the direction of the arrow
1
›
Remove the cover for the mounting recess
downwards direction.
›
Put the tow bar in the ready position
›
Grip the tow bar from underneath
cess in arrow direction
until you hear it click into place
3
The handwheel
» Fig. 156
returns automatically and rests on the tow bar
C
»
.
on page 141 first.
» Fig. 156
at the handle
, release in the
B
A
» Fig. 153
on page 142 in a
4
» page
142.
» Fig. 156
and insert into the mounting re-
»
.
Hitch and trailer
.
2
143