Skoda YETI Owner's Manual page 62

The window lift mechanism is equipped with protection against overheating.
Repeated opening and closing of the window can cause this mechanism to
overheat. If this happens, it will not be possible to operate the window for a
short time. You will be able to operate the window again as soon as the over-
heating protection has cooled down.
WARNING
The system is fitted with a force limiter
■
cle, the closing process is stopped and the window goes down by several
centimetres. However, the windows should be closed carefully – risk of in-
jury.
If the rear seats are accommodating people who are not completely inde-
■
pendent, e.g. children, it is recommended that for safety reasons the but-
tons in the rear doors are disabled with the button
CAUTION
In the winter, ice accumulating on the surface of the window may cause
■
there to be more resistance when closing the window. The window will stop
and move back several centimetres.
Keep the windows clean to ensure the correct functionality of the electric
■
windows.
Always close the windows before disconnecting the battery.
■
Opening the windows in the front passenger door and in the rear
doors

Read and observe and
There is a button in the front passenger door and in the rear doors for that
window.
60
Using the system
» page 60. If there is an obsta-
.
E
Fig. 44
Power window button
on page 58 first.
Opening
›
Lightly press the button downwards and hold it until the window has moved
into the desired position.
Releasing the button causes the window to halt immediately.
The window can be completely opened automatically by briefly pressing the
down button as far as the stop. Renewed pressing of the button causes the
window to stop immediately.
Closing
›
Lightly press the button upwards and hold it until the window has moved in-
to the desired position.
Releasing the button causes the window to halt immediately.
The window can be completely closed automatically by briefly pressing the up
button as far as the stop. Releasing the button causes the window to halt im-
mediately.
Force limit

Read and observe and
The electrical power window system is fitted with a force limiter.
If there is an obstacle, the closing process is stopped and the window goes
down by several centimetres.
If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down
by several centimetres.
If you attempt to close the window again within 10 seconds of the window be-
ing moved down for the second time, even though the obstacle was not yet
been removed, the closing process is only stopped. During this time it is not
possible to automatically close the window. The force limiter is still switched
on.
The force limiter is only switched off if you attempt to close the window again
within the next 10 seconds - the window will now close with full force!
If you wait longer than 10 seconds, the force limiter is switched on again.
on page 58 first.