Fitting
›
Insert the connector into the light and lock it securely.
›
Insert the light into the mounts in the body
›
Carefully press the light into the body so that the bolts
page 203 or
» Fig. 214
on page 203 on the light engage into the mounts on
the body.
›
Screw the light with the screws into place
Replacing bulbs in rear light
Fig. 213 Inner part of the light: Ground light
Fig. 214 Inner part of the light: Light with LED diodes
Read and observe
and
Ground light
›
With the spanner from the vehicle tools unscrew the securing screw
» Fig.
213.
›
Unlock the bulb holder using the locking latches in the areas
marked with arrows and remove the bulb holder from the light.
» Fig.
212.
» Fig. 213
1
» Fig.
212.
on page 199 first.
» Fig. 213
›
Turn the respective bulb
from the bulb holder.
›
Insert a new bulb
on
stop.
›
Pull bulb
out of the socket and insert a new bulb.
C
›
Insert the bulb holder in the light.
The lamp holder must engage audibly.
Light with LED diodes
›
Unlock the bulb holder using the locking latches in the areas
marked with arrows and remove the bulb holder from the light.
›
Turn the respective light bulb
remove it from the bulb holder.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Insert the bulb holder in the light.
The lamp holder must engage audibly.
Note
Visit a specialist garage if an LED diode is faulty.
A
until it stops counter-clockwise and remove it
B
into the holder and turn in a clockwise direction to the
B
» Fig. 214
until it stops counter-clockwise and
Fuses and light bulbs
» Fig. 214
203