Adjusting The Ready Position; Correctly Adjusted Ready Position - Skoda Octavia Operating Instructions Manual

Ball rod
6
Operating lever
7
Lock cap
8
Trigger pin
9
Lock
10
Locking ball
11
Key – Version 1
12
Key – Version 2
13
Note
If you lose the key, please get in touch with a specialist garage.

Adjusting the ready position

Fig. 179 First Step: Key Version 1 / key Version 2

Read and observe and
The ball rod must be set to the ready position prior to installation

Correctly adjusted ready position.

Fig. 180
Second Step: both key variants
on page 166 first.
If it is not in the ready position, then it must be set to the ready position as
follows.
First Step - applies to the key version 1
›
Remove the cap from the lock
›
Insert key
A
›
Turn key in the direction of arrow
A
upwards » Fig.
First Step - applies to the key version 2
›
Remove the cap from the lock
›
Insert key
B
›
Turn the key in the direction of arrow
shows up » Fig.
Second Step - applies to both key versions
›
Grip the tow bar below the protective cap.
›
Push release pin
ously push operating lever
» Fig. 180.
Operating lever
Correctly adjusted ready position
Fig. 181 Ready position: Key Version 1 / key Version 2 / position of the
lever and the release bolt with two key versions

Read and observe
Correctly adjusted standby position
Applies to key version 1 - the red marking on key

» page 167,
Applies to key version 2 - the eye of the key

into the lock so that the green marking is pointing upwards.
so that the red marking is pointing
1
179.
into the lock so that the eye of the key is pointing downwards.
so that the conclusions release
B 2
179.
in the direction of arrow
C 3
in the direction of arrow
D
remains locked in this position.
D
and on page 166 first.
» Fig. 181
to the stop, and simultane-
to the stop
4
is pointing upwards.
A
is pointing upwards.
B

167
Hitch and trailer