Fuses And Light Bulbs; Fuses - Skoda YETI Owner's Manual

Hide thumbs Also See for YETI:
Table of Contents

Advertisement

The windscreen wiper arms move back into the rest position - after switching
on the ignition and changing the position of the window wiper lever or when
driving at a speed of more than 6°km/h.
CAUTION
If the windscreen wipers are handled carelessly, there is a risk of damage to
the windscreen.
Replacing the rear window wiper blade
Fig. 200 Rear window wiper blade
Read and observe
on page 195 first.
Removing the wiper blade
Lift the wiper arm from the windscreen in the direction of
Tilt the wiper blade to the stop in the same direction.
Hold the upper part of the wiper arm and press the securing mechanism
in the direction of arrow
.
2
Remove the wiper blade in the direction of the arrow
Attaching the windscreen wiper blade
Push the windscreen wiper blade to the stop until it locks into place.
Check that the windscreen wiper blade is correctly attached.
Fold the wiper arm back to the windscreen.
196
Do-it-yourself

Fuses and light bulbs

Fuses

This chapter contains information on the following subjects:
Fuses in the dash panel
Assignment of the fuses in the dash panel
Fuses in the engine compartment
Assignment of fuses in the engine compartment
Individual electrical circuits are protected by fuses.
Switch off the ignition and the corresponding power consuming device before
replacing a fuse.
Find out which fuse belongs to the component that is not operating
» page
partment.
Colour coding of fuses
» Fig.
200.
1
A
.
3
WARNING
Always read and observe the warnings before completing any work in the
engine compartment
Introduction
197, Fuses in the dash panel or
Fuse colour
light brown
dark brown
red
blue
yellow
white
green
orange
red
» page
165.
» page
198, Fuses in the engine com-
Maximum amperage
5
7.5
10
15
20
25
30
40
50
197
197
198
198

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents