Rear View Camera - Skoda YETI Owner's Manual

Hide thumbs Also See for YETI:
Table of Contents

Advertisement

Activation/deactivation
Read and observe
and
Activation
The activation of the system is initiated when the reverse gear is engaged, or
vehicles with the Variant 2 and 3 , also by pressing the symbol key 
» Fig.
146.
This is confirmed by a short acoustic signal ( the symbol  in the button is lit).
Deactivation
On vehicles with Version 1, the system can be deactivated by moving out of re-
verse gear.
For vehicles with the Version 2 and 3 the system is automatically deactivated
by pressing the symbol key or at a speed over 15 km / h (the symbol in the
button goes out).
Fault display
If a warning signal sounds for about 3 seconds after activating the system and
there is no obstacle close to your car, this indicates a system fault. The fault is
also indicated by the symbol  flashing in the button. Seek help from a spe-
cialist garage.
Note
The system can only be activated with the symbol key at a speed of below
15 km / hr.
Fig. 146
System key (option 2, 3)
on page 131 first.

Rear View Camera

Introduction
This chapter contains information on the following subjects:
Operation
Guidelines and function keys
The rear view camera (hereinafter referred to as system) helps the driver when
parking and manoeuvring by displaying the area behind the vehicle in the Info-
tainment display (hereinafter referred to as display).
WARNING
The general information relating to the use of assistance systems must
be observed
» page 127,
in section Introduction.
Make sure that the camera lens is not dirty or covered, otherwise the sys-
tem function can be significantly impaired. For information on cleaning
» page
156, Camera lens
CAUTION
The camera lens distorts and enlarges the field of view of the difference in
eye sight. The display is therefore only of limited use for estimating distances
to following vehicles.
Some items, such as thin columns, chain link fences or lattice may not be
represented adequately in terms of display resolution.
It is only a two-dimensional display. Therefore, protruding objects or roadway
depressions, for example, may not be recognised due to lack of space depth.
In a crash or damage the vehicle's rear camera can possibly deviate from the
correct position. If this is the case, have the sensor checked by a specialist ga-
rage.
134
134
133
Assist systems

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents