Skoda YETI Owner's Manual page 202

WARNING (Continued)
Bulbs H7 and H4 are pressurised and may burst when changed - there is a
■
risk of injury. We therefore recommended wearing gloves and safety
glasses when changing a bulb.
Do not carry out any work on the Xenon gas discharge lamps - risk of
■
death!
CAUTION
Do not take hold of the glass bulb with naked fingers (even the smallest
amount of dirt reduces the working life of the light bulb). Use a clean cloth,
napkin, or similar.
Note
This Owner's Manual only describes the replacement of bulbs where it is pos-
■
sible to replace the bulbs on your own without any complications arising. Other
bulbs must be replaced by a specialist garage.
We recommend that a box of replacement bulbs always be carried in the ve-
■
hicle. Replacement bulbs can be purchased from ŠKODAOriginal Accessories.
Bulb arrangement in the headlights

Read and observe and
The vehicle is equipped with headlights with halogen lamps or with a xenon
discharge lamp and a halogen bulb.
Bulb arrangement » Fig. 205
Low beam with halogen bulb or xenon gas discharge lamp
A
Main beam
B
200
Do-it-yourself
Fig. 205
Principle sketch: Front head-
lights
on page 199 first.
Replace the bulb for the dipped and main beam (Halogen
headlamp)
Fig. 206 Replacing the bulb for low beam and main beam

Read and observe and
›
Turn the respective protective cap
and remove.
When removing the cap, make sure that this does not fall into the engine com-
partment.
›
Disconnect the relevant connector with the light bulb in the direction of ar-
row » Fig. 206.
1
›
Remove the connector to the bulb in the direction of arrow
›
Remove the connector.
›
Insert the connector with the new bulb so that the fixing lug
bulb into the recess on the reflector.
›
Insert the respective protective cap
clockwise until it stops.
Note
We recommend you have the bulb replacement performed by a specialist ga-
rage.
on page 199 first.
» Fig. 205 on page 200 counter-clockwise
.
2
A
» Fig. 205 on page 200 and rotate it
adjusts the