Roof Rack - Skoda YETI Owner's Manual

Securing the loading floor in the raised position
›
Fold up the hooks on the fastening strip in direction of arrow
page 98.
›
Fold up the variable loading floor behind the rear back backrests.
›
Fold down the hooks in direction of arrow
the stop.
›
Support the variable loading floor on the hooks folded downwards
Removing and refitting carrier rails
Fig. 120 Slacken check points/remove carrier rails
Removing
›
Undo the securing points » Fig. 120
B
key or a flat screwdriver.
›
Hold the carrier rail in the front area and remove by pulling in the direction
A
of arrow .
1
›
Hold the carrier rail in the rear area and loosen and remove by pulling in
A
the direction of arrow .
2
Fig. 119
Secured loading floor in the
raised position
» Fig. 111
1
» Fig. 111 on page 98 as far as
3
» Fig.
on the carrier rails using the vehicle
Fitting
›
Position the carrier rails on the sides of the boot.
›
Press the two securing points
›
Check the attachment of the carrier rails by pulling it.
WARNING
Pay attention when installing the variable loading floor that the carrier rails
and the variable loading floor are correctly fixed, otherwise the occupants
are at risk.
Using the variable loading floor with a spare wheel
on
119.
Fig. 121 Fold up the side panels of the variable loading floor / space under
the variable loading floor
The sides of the variable loading floor can be folded in the direction of arrow
» Fig. 121 - .
The room under the variable loading floor
objects.

Roof rack


Introduction
This chapter contains information on the following subjects:
Roof load
» Fig. 120 on each carrier rail to the stop.
B
» Fig. 121 -  can be used to stow
Transporting and practical equipment
104

103