Variable Loading Floor In The Luggage Compartment (Estate); Class N1 Vehicles - Skoda YETI Owner's Manual

Removed from the holder
›
Grasp the lamp in the areas of the arrow
rection of the arrow .
1
Use of removed light
›
Press the button » Fig. 117 - the lamp lights up.
C
›
Press button once again - the light goes out.
C
Reinserting the lamp the holder
›
Switch off the ignition » .
›
First of all, place the deactivated light in the holder on the side facing the
boot lid and then press on the light from the other side until it is clicks into
place.
Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries.
The rechargeable batteries are constantly charged when the engine is running.
It takes approx. 3 hours to fully charge the rechargeable batteries.
Replace batteries » page 193.
CAUTION
If the lamp is not switched off and correctly inserted in the holder, the LEDs
■
in the front part » Fig. 117 of the lamp are automatically switched off.
A
If the lamp is not correctly inserted into the holder, this does not light up
■
when the boot lid is opened and the rechargeable batteries are not charged.
The lamp is not watertight and must therefore be protected against mois-
■
ture.

Class N1 vehicles


Read and observe and
On class N1 vehicles, which are not fitted with a protective grille, a lashing set
which complies with the standard EN 12195 (1 - 4) must be used for fastening
the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.
102
Using the system
» Fig. 117 and swivel it in the di-
D
on page 96 first.

Variable loading floor in the luggage compartment (Estate)


Introduction
This chapter contains information on the following subjects:
Removing and inserting the variable loading floor
Securing the loading floor in the raised position
Removing and refitting carrier rails
Using the variable loading floor with a spare wheel
The maximum permissible load of the variable loading floor is 75 kg.
The variable loading floor makes it easier to handle bulky goods and creates an
even boot floor when the rear seat backrests are folded forward.
Removing and inserting the variable loading floor
Fig. 118 Fold up / removal variable loading floor
›
Fold the variable loading floor together using the handle
direction of » Fig. 118.
1
›
Fold up the variable loading floor in direction of arrow
›
Pull on both sides of the locking levers in direction of arrow
›
Remove the variable loading floor in direction of arrow
Insertion takes place in reverse order.
102
103
103
103
and fold in the
A
.
2
.
3
.
4