Automatic Driving Lamp Control; Xenon Headlight - Skoda YETI Owner's Manual

Hide thumbs Also See for YETI:
Table of Contents

Advertisement

The headlight flasher can be operated even if the ignition is switched off.
The turn signal light switches itself off automatically when driving around a
curve or after making a turn.
"Convenience turn signal"
When the control lever is lightly pressed to the pressure point
the respective turn-signal lamp flashes three times.
The "Lane ch. flash" can be activated / deactivated via the Maxi DOT display in
the Lane ch.
flash» page
47, Menu item Settings menu item.
WARNING
Only turn on the main beam or the headlight flasher if other road users will
not be dazzled.

Automatic driving lamp control

Read and observe
on page 64 first.
The light switch is in position 
the automatic switch on / off the lights corresponding to the light or weather
conditions (rain) takes place.
If the light switch is in position , the lettering  illuminates next to the
light switch. If the light is switched on automatically, the symbol  next to the
light switch also lights up.
Automatic driving light control during rain
The daytime running lights are switched on automatically if the following con-
ditions are met:
The light switch is in the position .
The windscreen wipers are on for more than 15 s.
66
Using the system
or
A
Fig. 49
Light switch: AUTO position
» Fig. 49
then depending on the equipment
The light turns off about 4 minutes after turning off the wipers.
CAUTION
Poorer visibility is evaluated by a motor mounted below the windscreen in the
holder of the interior mirror sensor. Do not attach any stickers or similar ob-
jects in front of the light sensor on the windscreen in order to avoid impairing
then
B
the function or its reliability.

Xenon headlight

Read and observe
The Xenon headlight (hereinafter referred to as system) ensures that the
roads are illuminated independent of the traffic and weather conditions.
The system automatically adjusts the light cone in front of the vehicle due to
the driving data (e.g. vehicle speed and load conditions, steering angle, using
the wiper).
The system works as long as the light switch is in position .
The system operates automatically in the following modes.
Out of town mode
The cone of light in front of the vehicle is similar to the low beam.
City mode
The cone of light in front of the vehicle is adapted so that the adjacent side-
walks, crossings, pedestrian crossings, etc., are also illuminated. The mode is
active at speeds of 15-50 km/h.
Motorway mode
The cone of light in front of the vehicle is adjusted so that the driver can re-
spond in time to an obstruction or other hazard in time. The mode is active at
speeds above 120 km/h.
Rain mode
The cone of light in front of the vehicle is adjusted so that the driver can re-
duce the glare from oncoming vehicles in rain.
The mode is active at speeds of 20-70 km/h and if the windscreen wipers con-
tinuously operate for a period of time longer than about 2 minutes. The deacti-
vation of the mode is carried out a few minutes after switching off the wiper.
on page 64 first.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents