Figure 30-6 Menu 15.1.1: First Set - ZyXEL Communications ZyWall 10W User Manual

The entire set will be deleted if you leave the Set Name field blank and press
Set Name= NAT_SET
Idx Local Start IP
--- ---------------
1.
2
3.
4.
5.
6.
7.
8.
9.
10.
The Type, Local and Global Start/End IPs are configured in menu 15.1.1.1
Ordering Your Rules
Ordering your rules is important because the ZyWALL applies the rules in the order that you specify. When
a rule matches the current packet, the ZyWALL takes the corresponding action and the remaining rules are
ignored. If there are any empty rules before your new configured rule, your configured rule will be pushed
up by that number of empty rules. For example, if you have already configured rules 1 to 6 in your current
set and now you configure rule number 9. In the set summary screen, the new rule will be rule 7, not 9.
Now if you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so as old rule 5 becomes rule 4, old rule 6
becomes rule 5 and old rule 7 becomes rule 6.
FIELD
Set Name Enter a name for this set of rules. This is a required field. If this field is left
blank, the entire set will be deleted.
NAT
[ENTER] are the bottom of the screen.
Menu 15.1.1 - Address Mapping Rules
Local End IP
---------------
Action= Edit
Press ENTER to Confirm or ESC to Cancel:

Figure 30-6 Menu 15.1.1: First Set

(described later) and the values are displayed here.
Table 30-3 Fields in Menu 15.1.1
ZyWALL Series Internet Security Gateway
Global Start IP Global End IP
--------------- ---------------
Select Rule=
DESCRIPTION
Type
------
EXAMPLE
NAT_SET
30-7