Figure 35-16 Menu 24.7.1 As Seen Using The Console Port - ZyXEL Communications ZyWall 10W User Manual

ZyWALL Series Internet Security Gateway
35.5.8 Uploading Firmware File Via Console Port
Step 1.
Select 1 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.1
- System Maintenance - Upload System Firmware, and then follow the instructions as shown
in the following screen.
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning: Proceeding with the upload will erase the current system
firmware.

Figure 35-16 Menu 24.7.1 As Seen Using the Console Port

Step 2.
After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.
35-16
Do You Wish To Proceed:(Y/N)
Firmware and Configuration File Maintenance