Figure 28-3 Menu 11.1: Remote Node Profile For Pppoe Encapsulation - ZyXEL Communications ZyWall 10W User Manual

Rem Node Name= ChangeMe
Active= Yes
Encapsulation= PPPoE
Service Type= Standard
Service Name=
Outgoing:
My Login=
My Password= ********
Retype to Confirm= ********
Authen= CHAP/PAP
Press Space Bar to Toggle.

Figure 28-3 Menu 11.1: Remote Node Profile for PPPoE Encapsulation

Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons.
However, some vendor's implementation includes a specific authentication protocol in the user profile. It
will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If you encounter a case where the peer disconnects right after a
successful authentication, please make sure that you specify the correct authentication protocol when
connecting to such an implementation.
Nailed-Up Connection
A nailed-up connection is a dial-up line where the connection is always up regardless of traffic demand.
The ZyWALL does two things when you specify a nailed-up connection. The first is that idle timeout is
disabled. The second is that the ZyWALL will try to bring up the connection when turned on and whenever
the connection is down. A nailed-up connection can be very expensive for obvious reasons.
Do not specify a nailed-up connection unless your telephone company offers flat-rate service or you need a
constant connection and the cost is of no concern.
The following table describes the fields not already described in Table 28-1.
Remote Node Setup
Menu 11.1 - Remote Node Profile
Press ENTER to Confirm or ESC to Cancel:
ZyWALL Series Internet Security Gateway
Route= IP
Edit IP= No
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedules=
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Edit Traffic Redirect= No
28-5