Menu 25.1 shows the summary of a policy set, including the criteria and the action of a single policy, and
whether a policy is active or not. Each policy contains two lines. The former part is the criteria of the
incoming packet and the latter is the action. Between these two parts, separator "|" means the action is taken
on criteria matched and separator "=" means the action is taken on criteria not matched.
# A
- - --------------------------------------------------------------------------
1 Y SA=1.1.1.1-1.1.1.1,DA=2.2.2.2-2.2.2.5
SP=20-25,DP=20-25,P=6,T=NM,PR=0
2 N __________________________________________________________________________
__________________________________________________________________________
3 N __________________________________________________________________________
__________________________________________________________________________
4 N __________________________________________________________________________
__________________________________________________________________________
5 N __________________________________________________________________________
__________________________________________________________________________
6 N __________________________________________________________________________
__________________________________________________________________________
Enter Policy Rule Number (1-6) to Configure:
Figure 38-3 Menu 25.1: Sample IP Routing Policy Setup
ABBREVIATION
Criterion
Action
IP Policy Routing
Menu 25.1 - IP Routing Policy Setup
Criteria/Action
Table 38-1 IP Routing Policy Setup
SA
Source IP Address
SP
Source Port
DA
Destination IP Address
DP
Destination Port
P
IP layer 4 protocol number (TCP=6, UDP=17...)
T
Type of service of incoming packet
PR
Precedence of incoming packet
GW
Gateway IP address
T
Outgoing Type of service
P
Outgoing Precedence
ZyWALL Series Internet Security Gateway
|GW=192.168.1.1,T=MT,PR=0
MEANING
38-3