Tftp Command Example; Table 35-3 General Commands For Gui-Based Tftp Clients - ZyXEL Communications ZyWall 10W User Manual

ZyWALL Series Internet Security Gateway
Step 5. Use the TFTP client (see the example below) to transfer files between the ZyWALL and the
computer. The file name for the configuration file is "rom-0" (rom-zero, not capital o).
Note that the telnet connection must be active and the SMT in CI mode before and during the TFTP
transfer. For details on TFTP commands (see following example), please consult the documentation of your
TFTP client program. For UNIX, use "get" to transfer from the ZyWALL to the computer and "binary" to
set binary transfer mode.

35.3.7 TFTP Command Example

The following is an example TFTP command:
tftp [-i] host get rom-0 config.rom
Where "i" specifies binary image transfer mode (use this mode when transferring binary files), "host" is the
ZyWALL IP address, "get" transfers the file source on the ZyWALL (rom-0, name of the configuration file
on the ZyWALL) to the file destination on the computer and renames it config.rom.
35.3.8 GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 35-3 General Commands for GUI-based TFTP Clients

COMMAND
Host Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL's default IP address
when shipped.
Send/Fetch Use "Send" to upload the file to the ZyWALL and "Fetch" to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the ZyWALL. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to section 35.3.5 to read about configurations that disallow TFTP and FTP over WAN.
35-6
DESCRIPTION
Firmware and Configuration File Maintenance