ZyXEL Communications ZyWall 10W User Manual page 236

ZyWALL Series Internet Security Gateway
LABEL
Local
Address Type
Starting IP
Address
Ending IP
Address/Subnet
Mask
Remote
Address Type
Starting IP
Address
15-26
Table 15-9 VPN Manual Key
Local IP addresses must be static and correspond to the remote IPSec router's
configured remote IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You can
configure multiple SAs between the same local and remote IP addresses, as long as
only one is active at any time.
Use the drop-down list box to choose Single Address, Range Address, or Subnet
Address. Select Single Address for a single IP address. Select Range Address for
a specific range of IP addresses. Select Subnet Address to specify IP addresses on
a network by their subnet mask.
When the Address Type field is configured to Single Address, enter a (static) IP
address on the LAN behind your ZyWALL. When the Address Type field is
configured to Range Address, enter the beginning (static) IP address, in a range of
computers on the LAN behind your ZyWALL. When the Address Type field is
configured to Subnet Address, this is a (static) IP address on the LAN behind your
ZyWALL.
When the Address Type field is configured to Single Address, this field is N/A.
When the Address Type field is configured to Range Address, enter the end (static)
IP address, in a range of computers on the LAN behind your ZyWALL. When the
Address Type field is configured to Subnet Address, this is a subnet mask on the
LAN behind your ZyWALL.
Remote IP addresses must be static and correspond to the remote IPSec router's
configured local IP addresses.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You can
configure multiple SAs between the same local and remote IP addresses, as long as
only one is active at any time.
Use the drop-down list box to choose Single Address, Range Address, or Subnet
Address. Select Single Address with a single IP address. Select Range Address
for a specific range of IP addresses. Select Subnet Address to specify IP addresses
on a network by their subnet mask.
When the Address Type field is configured to Single Address, enter a (static) IP
address on the network behind the remote IPSec router. When the Addr Type field is
configured to Range Address, enter the beginning (static) IP address, in a range of
computers on the network behind the remote IPSec router. When the Address Type
field is configured to Subnet Address, enter a (static) IP address on the network
behind the remote IPSec router.
DESCRIPTION
VPN Screens