ZyXEL Communications ZyWall 10W User Manual page 650

ZyWALL Series Internet Security Gateway
LOG MESSAGE
Verifying Local ID failed:
IKE Packet Retransmit
Failed to send IKE Packet
Too many errors! Deleting SA
Phase 1 IKE SA process done
Duplicate requests with the same
cookie
IKE Negotiation is in process
No proposal chosen
Local / remote IPs of incoming
request conflict with rule <%d>
Cannot resolve Secure Gateway
Addr for rule <%d>
Peer ID: <peer id> <My remote
type> -<My local type>
vs. My Remote <My remote> -<My
remote>
vs. My Local <My local>-<My local>
Send <packet>
S-10
Chart S-13 IKE Logs
The connection failed during IKE phase 2 because the
router and the peer's Local/Remote Addresses don't match.
The router retransmitted the last packet sent because there
was no response from the peer.
An Ethernet error stopped the router from sending IKE
packets.
An SA was deleted because there were too many errors.
The phase 1 IKE SA process has been completed.
The router received multiple requests from the same peer
while still processing the first IKE packet from the peer.
The router has already started negotiating with the peer for
the connection, but the IKE process has not finished yet.
Phase 1 or phase 2 parameters don't match. Please check
all protocols / settings. Ex. One device being configured for
3DES and the other being configured for DES causes the
connection to fail.
The security gateway is set to "0.0.0.0" and the router used
the peer's "Local Address" as the router's "Remote
Address". This information conflicted with static rule #d; thus
the connection is not allowed.
The router couldn't resolve the IP address from the domain
name that was used for the secure gateway address.
The displayed ID information did not match between the two
ends of the connection.
The displayed ID information did not match between the two
ends of the connection.
The displayed ID information did not match between the two
ends of the connection.
A packet was sent.
DESCRIPTION
Log Descriptions