ZyXEL Communications ZyWall 10W User Manual page 416

ZyWALL Series Internet Security Gateway
FIELD
Retype to
Confirm
Server
Relogin Every
(min)
Route
Edit IP
Session Options
Edit Filter sets
Once you have configured this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
28.3.2 PPPoE Encapsulation
The ZyWALL supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use PPPoE
encapsulation when you're using the ZyWALL with a DSL modem as the WAN device. If you change the
Encapsulation to PPPoE, then you will see the next screen. Please see the Appendices for more
information on PPPoE.
28-4
Table 28-1 Fields in Menu 11.1
Type your password again to make sure that you have entered it
correctly.
This field is valid only when RoadRunner is selected in the Service
Type field. The ZyWALL will find the RoadRunner Server IP
automatically if this field is left blank. If it does not, then you must
enter the authentication server IP address here.
This field is available when you select Telia Login in the Service
Type field.
The Telia server logs the ZyWALL out if the ZyWALL does not log in
periodically. Type the number of minutes from 1 to 59 (30
recommended) for the ZyWALL to wait between logins.
This field refers to the protocol that will be routed by your ZyWALL –
IP is the only option for the ZyWALL.
This field leads to a "hidden" menu. Press [SPACE BAR] to select
Yes and press [ENTER] to go to Menu 11.3 - Remote Node
Network Layer Options.
This field leads to another "hidden" menu. Use [SPACE BAR] to
select Yes and press [ENTER] to open menu 11.5 to edit the filter
sets. See the Remote Node Filter section for more details.
DESCRIPTION EXAMPLE
*****
IP
No
(default)
No
(default)
Remote Node Setup