Figure 2-3 Example Xmodem Upload - ZyXEL Communications ZyWall 10W User Manual

Step 2.
Turn the ZyWALL off.
Step 3.
While pressing the RESET button, turn the ZyWALL on.
Step 4. Continue to hold the RESET button. The SYS LED will begin to blink and flicker very quickly
after about 10 or 15 seconds. This indicates that the defaults have been restored and the ZyWALL
is now restarting.
Step 5. Release the RESET button and wait for the ZyWALL to finish restarting.
2.3.2 Uploading a Configuration File Via Console Port
Step 1. Download the default configuration file from the ZyXEL FTP site, unzip it and save it in a folder.
Step 2. Turn off the ZyWALL, begin a terminal emulation software session and turn on the ZyWALL
again. When you see the message "Press Any key to enter Debug Mode within 3 seconds", press
any key to enter debug mode.
Step 3.
Enter "y" at the prompt below to go into debug mode.
Step 4.
Enter "atlc" after "Enter Debug Mode" message.
Step 5. Wait for "Starting XMODEM upload" message before activating Xmodem upload on your
terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 6. Click Transfer, then Send File to display the following screen.
Step 7. After successful firmware upload, enter "atgo" to restart the router.
Introducing the Web Configurator

Figure 2-3 Example Xmodem Upload

ZyWALL Series Internet Security Gateway
Type the configuration file's
location, or click Browse to
search for it.
Choose the Xmodem
protocol.
Then click Send.
2-3