Fuji Xerox DocuPrint CM215 Series User Manual page 91

Configuring Ethernet Connection Settings (DocuPrint CM215
f/CM215 fw Only)
1
Click the Ethernet button on the Select a Connection Method screen.
2
Connect the Ethernet cable to the printer and turn on the printer, and then click Next.
3
Select a printer you want to install from the Printer list, and then click Next.
If the target printer is not displayed on the Printer list, click the Refresh button to refresh the list
or click Enter IP Address to add a printer manually.
In Enter IP Address, enter assigned IP address to the printer manually, and then and click OK.
NOTE:
• If the target printer is not displayed on the list, ensure Ethernet cable is correctly inserted to the printer
and the router. And also confirm the printer IP address is properly appointed.
4
Confirm IP Mode and Type, and then click Next.
If the target printer is not found, you can select from three options such as clicking Connect to
search the target printer again, clicking Search after disabling firewall in your computer, or
clicking Start Over to go back to the top screen.
5
Check and configure the printer information such as a printer name, default printer setting, printer
sharing setting, specify whether to install the fax driver, and then click Next.
6
Select the check box of the software and documentation you want to install, and then click
Install.
You can specify a folder in which to install the software and documentation. To change
destination folder, click Browse.
7
Click Finish to exit the wizard when the Ready to Print! screen appears. If necessary, click
Print Test Page to print a test page.
Printer Connection and Software Installation 91