Fuji Xerox DocuPrint CM215 Series User Manual page 75

• WPS-PBC (WPS Button)
You can start WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) by pressing the
button.
NOTE:
• WPS-PBC is available only when the wireless LAN access point (Registrar) or router supports WPS-PBC.
• Before starting WPS-PBC with the
may vary) on the wireless LAN access point (Registrar) or router. For information about WPS operation on the
wireless LAN access point (Registrar) or router, refer to the manual supplied with the product.
• The (Wi-Fi) LED lights up or blinks to indicate the printer's wireless connection status. For more
information, see "Status of Wi-Fi LED (DocuPrint CM215 fw Only)" on page
If a problem occurs or error messages are displayed on the
CM215 fw Only)" on page
1
Press and hold the
Confirm that the
appears on the
1 2
3 4
5 6
7 8
2
Start the WPS operation on the wireless LAN access point (Registrar) or router within two
minutes.
When the WPS operation is successful and the printer is rebooted, wireless LAN connection
setting is completed.
(WPS) button, confirm the position of the WPS button (button name
396.
(WPS) button on the printer for two seconds.
(Wi-Fi) LED starts to blink slowly and Press WPS Button on Router
LCD panel.
Wi-Fi
WPS
LCD panel, see
@:./
ABC
1 2
GHI JKL MNO
4 5
OK
PQRS TUV WXYZ
7 8
-_ ˜
0
Printer Connection and Software Installation
49.
"Wireless Problems (DocuPrint
/
DEF
3
CA
6
9
# C
(WPS)
75