Figure 17: 8-Port 10-Gigabit Ethernet Sfp+ Uplink Module; Figure 18: Leds On The 8-Port 10-Gigabit Ethernet Sfp+ Uplink Module - Juniper EX4300 Hardware Manual

Table 16: Uplink Modules Used in 32-Port EX4300 Switches (continued)
Uplink Module
8-port 10-Gigabit Ethernet SFP+ uplink module
Copyright © 2015, Juniper Networks, Inc.
Figure

Figure 17: 8-Port 10-Gigabit Ethernet SFP+ Uplink Module

Figure 18: LEDs on the 8-Port 10-Gigabit Ethernet SFP+
Uplink Module
NOTE: When you install an uplink module in the switch or replace an uplink
module with another uplink module, the switch detects the ports on the uplink
module. The switch creates the required interfaces when transceivers are
installed in these ports.
The SFP+ uplink module ports can operate either in 10-gigabit or in 1-gigabit mode
depending on the transceiver you install in them. The operating mode for an SFP+ uplink
module is shown in the output of the
command.
number
Each port on the uplink modules has a pair of LEDs that indicate the link activity and
status of the port. See "Network Port, Built-In QSFP+ Port, Uplink Port, and Uplink Module
Port LEDs on EX4300 Switches" on page 36
LEDs.
Chapter 2: Chassis Components and Descriptions
1— Status LED of
the uplink
module
2— Link activity LED
of the lower port
3—Link activity LED
of the upper port
show chassis pic fpc-slot slot number pic-slot slot
for details about the status and link activity
4— Status LED the
lower port
5— Status LED the
upper port
33