Connecting And Configuring An Ex Series Switch (Cli Procedure) - Juniper EX4300 Hardware Manual

Related
Documentation

Connecting and Configuring an EX Series Switch (CLI Procedure)

Copyright © 2015, Juniper Networks, Inc.
interface ge-0/0/41;
interface ge-0/0/42;
interface ge-0/0/43;
interface ge-0/0/44;
interface ge-0/0/45;
interface ge-0/0/46;
interface ge-0/0/47;
interface ge-0/2/0;
interface xe-0/2/0;
interface ge-0/2/1;
interface xe-0/2/1;
interface ge-0/2/2;
interface xe-0/2/2;
interface ge-0/2/3;
interface xe-0/2/3;
}
}
vlans {
default {
vlan-id 1;
}
}
poe {
interface-all;
}
Reverting to the Default Factory Configuration for the EX Series Switch
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 205
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 208
Understanding Configuration Files for EX Series Switches
EX Series Switches Interfaces Overview
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
NOTE: EX2200-24T-4G-DC switches do not support switch connection and
configuration through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See Reverting to the Default Factory Configuration for the EX Series Switch.
Chapter 14: Performing Initial Configuration
ezsetup script, the switch must have the factory default
, revert to the factory default configuration.
ezsetup
205