Removing An Uplink Module From An Ex4300 Switch; Figure 76: Installing An 8-Port Sfp+ Uplink Module In A 32-Port Ex4300 - Juniper EX4300 Hardware Manual

Related
Documentation

Removing an Uplink Module from an EX4300 Switch

Copyright © 2015, Juniper Networks, Inc.

Figure 76: Installing an 8-Port SFP+ Uplink Module in a 32-Port EX4300

Switch
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp
Failure to do so can result in significant delays if you need replacement parts.
This note applies if you change the type of power supply or add a new type
of uplink module. It does not apply if you replace these components with the
same type of component.
Removing an Uplink Module from an EX4300 Switch on page 231
Installing a Transceiver in an EX Series Switch on page 235
Installing and Removing EX4300 Switch Hardware Components on page 165
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
EX4300 Switches Hardware Overview on page 3
The uplink module in EX4300 switches is hot-removable and hot-insertable
field-replaceable unit (FRU): You can remove and replace it without powering off the
switch or disrupting switch functions.
Before you begin removing an uplink module from the switch:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage (see "Prevention of Electrostatic Discharge Damage" on page
If there are any transceivers installed in the uplink module, remove them before you
remove the uplink module. For instructions on removing transceivers, see
a Transceiver from a Switch" on page
Ensure that you have the following parts and tools available:
ESD grounding strap
Phillips (+) screwdriver, number 2
A replacement uplink module or cover panel
An antistatic bag or antistatic mat
Chapter 17: Replacing Uplink Module
237.
.
299).
"Removing
231