Special Instructions To Follow Before Connecting Earth Ground To A; Switch; Table 87: Special Instructions To Follow Before Connecting Earth Ground To A - Juniper EX4300 Hardware Manual

EX4300 Switch Hardware Guide
Table 86: Parts and Tools Required for Connecting an EX Series Switch to Earth
Ground (continued)
Earthing
Terminal Grounding Cable

Switch

Location Requirements
EX9204 Rear panel One 6 AWG (13.3
of chassis mm²), minimum
60°C wire, or one
that complies with
the local code
EX9208 Rear panel One 6 AWG (13.3
of chassis mm²), minimum
60°C wire, or one
that complies with
the local code
EX9214 Rear panel One 6 AWG (13.3
of chassis mm²), minimum
60°C wire, or one
that complies with
the local code
Special Instructions to Follow Before Connecting Earth Ground to a Switch
Table 87: Special Instructions to Follow Before Connecting Earth Ground to a Switch
Switch Special Instructions
EX3200 NOTE: Some early variants of EX3200 switches for which the Juniper Networks model number on the label
next to the protective earthing terminal is from 750-021xxx through 750-030xxx require 10-24x.25 in. screws.
170
Grounding Lug
Specifications
Thomas&Betts
LCN6-14 or
equivalent—
provided
Thomas&Betts
LCN6-14 or
equivalent—
provided
Thomas&Betts
LCN6-14 or
equivalent—
provided
Table 87 on page 170 lists the special instructions that you might need to follow before
connecting earth ground to a switch.
Screws and
Washers Screwdriver
Two ¼-20 Phillips (+)
x 0.5 in. screws number 2
with #¼"
split-washer—
provided
Two #¼" flat
washers—
provided
Two ¼-20 Phillips (+)
x 0.5 in. screws number 2
with #¼"
split-washer—
provided
Two #¼" flat
washers—
provided
Two ¼-20 Phillips (+)
x 0.5 in. screws number 2
with #¼"
split-washer—
provided
Two #¼" flat
washers—
provided
Copyright © 2015, Juniper Networks, Inc.
Additional
Information
See Grounding
Cable and Lug
Specifications for
EX9200 Switches.
See Grounding
Cable and Lug
Specifications for
EX9200 Switches.
See Grounding
Cable and Lug
Specifications for
EX9200 Switches.