Chassis Lifting Guidelines For Ex4300 Switches - Juniper EX4300 Hardware Manual

Chassis Lifting Guidelines for EX4300 Switches

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Connecting DC Power to an EX9204 Switch
Connecting DC Power to an EX9208 Switch
Connecting DC Power to an EX9214 Switch
Connecting AC Power to an XRE200 External Routing Engine
Connecting DC Power to an XRE200 External Routing Engine
Connecting AC Power to an OCX1100 Switch
Connecting DC Power to an OCX1100 Switch
Connecting AC Power to a QFX3100 Director Device
Connecting AC Power to a QFX3008-I Interconnect Device with Single-Phase Wiring
Trays
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Delta Wiring
Trays
Connecting AC Power to a QFX3008-I Interconnect Device with Three-Phase Wye Wiring
Trays
Connecting AC Power to a QFX3500, QFX3600, or QFX3600-I Device
Connecting DC Power to a QFX3500, QFX3600, or QFX3600-I Device
Connecting AC Power to a QFX5100 Device
Connecting DC Power to a QFX5100 Device
The weight of an EX4300 switch is approximately 13 lb (5.9 kg). Observe the following
guidelines for lifting and moving the switch:
Before moving the switch to a site, ensure that the site meets the power, environmental,
and clearance requirements specified in the
Switches" on page 83.
Before lifting or moving the switch, disconnect all external cables and wires.
As when lifting any heavy object, ensure that most of the weight is borne by your legs
rather than your back. Keep your knees bent and your back relatively straight. Do not
twist your body as you lift. Balance the load evenly and be sure that your footing is firm.
General Safety Guidelines and Warnings on page 265
Installation Instructions Warning on page 273
Mounting an EX4300 Switch on page 156
Chapter 24: Installation Safety Guidelines and Warnings
"Site Preparation Checklist for EX4300
275