Figure 56: Connecting A Switch To A Management Console Through A Console; Figure 57: Connecting A Switch Directly To A Management Console; Server - Juniper EX4300 Hardware Manual

EX4300 Switch Hardware Guide
184
See EX2200 Switches Hardware Overview.
See Rear Panel of an EX3200 Switch.
See Rear Panel of an EX3300 Switch.
See Rear Panel of an EX4200 Switch.
See "EX4300 Switches Hardware Overview" on page 3
See Front Panel of an EX4500 Switch.
See EX4550 Switches Hardware Overview
See Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.
See Routing Engine (RE) Module in an EX8216 Switch.
See Front Panel of an XRE200 External Routing Engine.
See Management Panel of an EX4600 Switch
OCX1100 Switches Hardware Overview
Connect the other end of the Ethernet cable into the console server (see
2.
Figure 56 on page 184) or management console (see
To configure the device from the management console, see
an EX Series Switch (CLI Procedure)" on page 205
Series Switch (J-Web Procedure)" on page 208
Switch (CLI Procedure).
NOTE: EX2200-24T-4G-DC and OCX1100 switches do not support switch
connection and configuration through the J-Web interface.
Figure 56: Connecting a Switch to a Management Console Through a
Console Server

Figure 57: Connecting a Switch Directly to a Management Console

Figure 57 on page
"Connecting and Configuring
or "Connecting and Configuring an EX
or Connecting and Configuring an OCX1100
Copyright © 2015, Juniper Networks, Inc.
184).