Mounting An Ex4300 Switch On Four Posts Of A Rack Or Cabinet; Figure 43: Mounting The Switch On Two Posts Of A Rack - Juniper EX4300 Hardware Manual

Related
Documentation

Mounting an EX4300 Switch on Four Posts of a Rack or Cabinet

Copyright © 2015, Juniper Networks, Inc.

Figure 43: Mounting the Switch on Two Posts of a Rack

Mounting rack
Have a second person secure the switch to the rack by using the appropriate screws.
7.
Tighten the screws.
Ensure that the switch chassis is level by verifying that all screws on one side of the
8.
rack are aligned with the screws on the other side.
NOTE: We recommend that you install cover panels in the unused uplink
module and power supply slots.
Connecting Earth Ground to an EX Series Switch on page 167
Connecting AC Power to an EX4300 Switch on page 173
Connecting DC Power to an EX4300 Switch on page 176
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 205
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 208
Mounting an EX4300 Switch in a Recessed Position in a Rack or Cabinet on page 163
Rack-Mounting and Cabinet-Mounting Warnings on page 278
You can mount an EX4300 switch on four posts of a 19-in. rack or a 19-in. cabinet by
using the separately orderable four-post rack-mount kit. (The remainder of this topic
uses rack to mean rack or cabinet.)
You can mount the switch on two posts of either a two-post rack or a four-post rack by
using the mounting brackets provided with the switch. See
on Two Posts of a Rack or Cabinet" on page
Chapter 11: Installing the Switch
Mounting bracket
"Mounting an EX4300 Switch
157.
159